Amplifier Circuits: Buffers

300V PEAK TO PEAK SIGNAL GENERATOR (54) (300vpp) This circuit converts a square wave signal to a +-150 volt output signal with fast 100nS rise and fall times.

Applications for a New Ultra High Speed Buffer : National Semiconductor Application Notes, 04-Nov-1995

LM110 to an Improved IC Voltage Follower : National Semiconductor Application Notes, 28-Jun-1996

Single Resistor betters inexpensive Buffer

Hot Swap, Push-Pull, Sync. Buck, Negative Flyback, Dual Sync. Buck Reference Design: Hot Swap, Push-Pull, Sync. Buck, Negative Flyback, Dual Sync. Buck with Vin of -36 V to -72V. Vout of 8 V, 5 V, 3.3 V, 2.5 V and -5 V. The output power is 79.5 W.

LM110 to An Improved IC Voltage Follower : National Semiconductor Application Notes,28-Jun-1996

Low-power CMOS oscillator has push-pull output:
Digital oscillators often generate TTL- or CMOS-level outputs, referred to ground. Generating a symmetric bipolar output with respect to ground presents a challenge. In this design, four 1.5V flashlight cells create ±3V voltage sources, and the midpoint of cells acts as the ground reference (Figure 1)....

Simple deadband generator targets push-pull drivers:
Electronic Design - Ideas for Design / In typical push-pull driver applications, the npn-pnp transistor pair is alternately turned on and off using a square-wave signal. A simple driver circuit uses an inverter between the V1 and V2. . .

Single Resistor Betters inexpensive Buffer: file contains multiple circuits - scroll to find this one